Inspection Procedure
WARNING: This page is about a different car, the 2008 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK PANEL SWITCH
- Check for foreign matter around the switch that might prevent operation.
OK: No foreign matter is found.
NG: REMOVE ANY FOREIGN MATTER
OK: Go to Next Step
- Check for foreign matter around the switch that might prevent operation.
- CHECK PANEL SWITCH (DISPLAY CHECK MODE)
- Enter the "Display Check" mode (Panel Switch Check Mode) (See SYSTEM NORMAL CONDITION CHECK ).
- Operate the abnormal switch and check if the switch name and status are correctly displayed.
OK: The switch name and status are correctly displayed as operated.
NG: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (See PROBLEM SYMPTOMS TABLE )
OK: REPLACE NAVIGATION RECEIVER ASSEMBLY (See REMOVAL )