LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2004 >> Viper >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake System - Abs >> Wheel Speed Sensor - Front >> Removal

Wheel Speed Sensor - Front: Removal

NOTE: Before proceeding review Warnings and Cautions. Refer to DISC and CAUTION  .
  1. Raise vehicle.
  2. Remove wheel and tire assembly. Refer to TIRES/WHEELS .
  3. Disconnect vehicle wiring harness from wheel speed sensor wiring connector at frame rail.
  4. Remove sensor wiring connector clip from frame rail.
  5. Remove sensor harness from routing clips along brake flex hose.
  6. Remove bolt fastening sensor head to steering knuckle (Fig 1 ).
    Fig 1: Removing Bolt Fastening Sensor Head To Steering Knuckle
    G03587553Courtesy of DAIMLERCHRYSLER CORP.
    CAUTION: When removing a wheel speed sensor from the knuckle, do not use pliers on the sensor head. This may damage the sensor head. If the sensor has seized, use a hammer and a punch to tap the edge of the sensor head ear, rocking the sensor side-to-side until free.
  7. Carefully remove sensor head from steering knuckle.
scientia non olet · About LEMON Manuals