Section 4 (Transmission - Removal And Installation)
WARNING: This page is about a different variant/trim than selected.
- Gear Selector (Automatic)
- Gear Selector (Manual)
- Boot, Gearshift Lever
- Gear Selector Assembly (M56)
- Gear Selector Assembly (M66)
- Gearshift Cable (M56)
- Notes
- Preparatory Work
- Removal
- Installation
- Notes
- Installing The Gear Selector Cables
- Installing The Cable Lead-In
- Installing The Gear Selector Cables In Gear Selector Assembly
- Installing Components In Transmission Tunnel
- Installing The Right-Hand Gear Selector Cable In The Transmission
- Installing The Left-Hand Gear Selector Cable In The Transmission
- Finishing
- Gearshift Cable (M66)
- Knob, Gear Selector Lever
- Mechanism, Gear Shift Selector
- Solenoid Gear Lever Assembly
- Transmission (Automatic)
- Cover, Control System
- Sealing Ring, Gear Shift Linkage Rod
- Sealing Ring, Torque Converter
- Temperature Sensor Fluid, Transaxle, (TFT) (Turbo)
- Temperature Sensor Fluid, Transaxle, (TFT) (Non-Turbo)
- Transmission Control Module (TCM)
- Transmission Control Unit Solenoids
- Transaxle Oil
- Transmission, Removal
- Transmission, Removing
- Notes
- Preparatory Work
- Removal
- Removing The SUBFRAME Screws
- Removing The Anti-Roll Bar
- Hanging Up The Steering Gear
- Removing The Sub-Frame
- Removing The Oil Line
- Removing The Screws From The Torque Converter
- Removing Engine Compartment Components
- Removing The Gear Selector Cable
- Removing The Bracket
- Removing The Engine And Transmission Screws
- Installing The Lifting Beam And Lifting Hook
- Lowering The Engine And The Gearbox
- Removing Engine Mounting
- Installing The Fixture On The Mobile Jack And Transmission
- Removing Screws
- Removing The Transmission
- Transmission, Removing
- Transmission, Installation
- Installation
- Notes
- Installing The Gearbox
- Installing And Tightening Screws For The Transmission
- Installing Engine Mounting
- Lifting Engine And Transmission
- Installing The Screws In The Transmission / Engine
- Installing The Bracket
- Installing The Gear Selector Cable
- Fitting Service Clips
- Installing The Air Cleaner (ACL) Module
- Fitting The Torque Converter Screws.
- Installing The Oil Line
- Installing The Sub-Frame
- Installing The Anti-Roll Bar
- Securing The SUBFRAME
- Installing The Screws
- Installing The Screws, Continued
- Finishing
- Installation
- Transmission (Manual)