Left/Right Front Level Control System Sensor -G78- / -G289-, Removing And Installing: Installing

WARNING: This page is about a different car, the 2021 Volkswagen Tiguan, 2020 Volkswagen Tiguan, 2019 Volkswagen Tiguan, and 2018 Volkswagen Tiguan. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

The level control system sensor lever must point toward vehicle exterior.

The thread on the vehicle level sensor must be installed into the exterior hole in the control arm. The tab on the vehicle level sensor bracket must lock into the inner hole in order to assure a correct installation position.

Perform the basic setting for the wheel damping electronics. Use the Vehicle Diagnostic Tester.
If the control position was reprogrammed and if the vehicle has lane assist, then it will then be necessary to calibrate the driver assistance systems front camera. Refer to DRIVER ASSISTANCE SYSTEMS FRONT CAMERA, CALIBRATING .
Adjust the headlamps to the basic setting. Refer to HEADLAMP, ADJUSTING .