Shift Lever: Installation: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL SHIFT LOCK CONTROL UNIT ASSEMBLY
1. Install the shift lock control unit assembly with the 3 nuts.
  Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
2. Connect the connector to the shift lock control unit assembly.
INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY . Refer to INSTALLATION - Step 30
INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY . Refer to INSTALLATION - Step 31
CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL
INSTALL DECK FLOOR BOX RH . Refer to INSTALLATION - Step 54
INSTALL REAR NO. 3 FLOOR BOARD . Refer to INSTALLATION - Step 55
INSPECT SHIFT LEVER
1. Turn the power switch on (READY).
2. Check that all available shift positions can be selected moving the shift lever.
  HINT:
  
  After the shift lock control unit assembly is replaced with a new one, perform the above operation. If this operation is not performed, moving the shift lever may not initially select shift positions.