LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2010 >> Tacoma Base, 4D Pickup, Automatic >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (1GR-FE) (Service Information) >> Crankshaft Position Sensor >> Removal >> Removal

Crankshaft Position Sensor: Removal: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE V-BANK COVER  See step  3
  3. REMOVE FAN SHROUD  . Refer to REMOVAL - Step 4
  4. REMOVE GENERATOR ASSEMBLY  . Refer to REMOVAL - Step 5
  5. SEPARATE COOLER COMPRESSOR ASSEMBLY 
    Fig 1: Identifying Bolt
    GTY180635Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the bolt, then separate the suction hose sub-assembly.
    2. Disconnect the cooler compressor assembly connector.
      Fig 2: Identifying Cooler Compressor Assembly Bolts
      GTY209670Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 4 bolts, then separate the cooler compressor assembly from the V-ribbed belt tensioner assembly.
  6. REMOVE CRANKSHAFT POSITION SENSOR 
    Fig 3: Identifying Crankshaft Position Sensor Bolt
    GTY187887Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the crankshaft position sensor connector.
    2. Remove the bolt, then remove the crankshaft position sensor.
scientia non olet · About LEMON Manuals