Fuel Lid Lock Control: Installation

WARNING: This page is about a different car, the 2009 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FUEL FILLER OPENING LID LOCK RETAINER
1. Install the lock retainer and turn it clockwise as shown in Fig 1.
  
  Fig 1: Installing Fuel Filler Opening Lid Lock Retainer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY
1. Attach the claw and install the cable to the lock retainer.
  
  Fig 2: Installing Fuel Lid Lock Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the cable from the clamps at the location shown in Fig 3.
  
  Fig 3: Connecting Cable From Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY
1. Connect the cable to the lever.
2. Install the lever with the screw.
Fig 4: Installing Fuel Lid Lock Open Lever Sub-Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH (See INSTALLATION )
INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (See INSTALLATION )
INSTALL CENTER PILLAR LOWER GARNISH LH (See INSTALLATION )
INSTALL REAR DOOR SCUFF PLATE LH (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE LH (See INSTALLATION )
INSTALL REAR SIDE SEATBACK ASSEMBLY LH (See INSTALLATION )
INSTALL REAR SEAT CUSHION ASSEMBLY (See INSTALLATION )
INSTALL FRONT SEAT ASSEMBLY LH
1. Install the seat (see INSTALLATION ).
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform INITIALIZATION .
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.