LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Tundra Base, 5.7 W >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Engine Control System (2TR-FE)) >> Crankshaft Position Sensor >> Removal

Crankshaft Position Sensor: Removal

WARNING: This page is about a different car, the 2009 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY NO.1 (for 4WD and Pre-Runner) 
  3. REMOVE FAN AND GENERATOR V BELT (W/ AIR CONDITIONING)  (See DRIVE BELT )
  4. SEPARATE COMPRESSOR AND MAGNETIC CLUTCH (W/ AIR CONDITIONING)  (See REMOVAL )
  5. REMOVE IDLE PULLEY ASSEMBLY WITH BRACKET (W/AIR CONDITIONING) 
    1. Remove the 5 bolts, then remove the idle pulley with bracket.
      Fig 1: Locating Bolts And Idle Pulley With Bracket
      G05198397Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the crankshaft position sensor connector and the 2 wire harness clamps.
      Fig 2: Locating Crankshaft Position Sensor Connector And Wire Harness Clamps
      G05198398Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt, then remove the crankshaft position sensor.
      Fig 3: Locating Bolt And Crankshaft Position Sensor
      G05198399Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals