Skid Control Buzzer: Removal
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
- Some systems need to be initialized after the cable is reconnected (see INITIALIZATION
).
- REMOVE FRONT DOOR SCUFF PLATE LH (for Regular Cab)
(See REMOVAL
)
- REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab, CrewMax)
(See
)
- REMOVE COWL SIDE TRIM BOARD LH
(See REMOVAL
)
- REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
(See REMOVAL
)
- REMOVE SKID CONTROL BUZZER ASSEMBLY
- Detach the clamp and remove the buzzer.
- Disconnect the buzzer connector.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002