Navigation Receiver: Installation

WARNING: This page is about a different car, the 2008 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL NO. 1 RADIO BRACKET
1. Install the bracket with the 4 bolts.
  
  Fig 1: Locating No. 1 Radio Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 2 RADIO BRACKET
1. Install the bracket with the 4 bolts.
  
  Fig 2: Locating No. 2 Radio Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET
1. Connect the connectors.
2. Insert the navigation receiver as shown in the illustration to engage the 3 clips on its backside.
  NOTE: When inserting the navigation receiver, do not press the knobs on it.
  
  Fig 3: Inserting Navigation Receiver To Engage Clips On Its Backside
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the navigation receiver with the 4 bolts.
INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY (See INSTALLATION )
INSTALL CENTER LOWER INSTRUMENT PANEL FINISH PANEL (See INSTALLATION )
INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (See INSTALLATION )
INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY (See INSTALLATION )
INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (See INSTALLATION )
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (See INSTALLATION )

Fig 4: Locating Navigation Receiver Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH (See INSTALLATION )
INSTALL INSTRUMENT SIDE PANEL LH (See INSTALLATION )
INSTALL COWL SIDE TRIM BOARD LH (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE LH (See INSTALLATION )