LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Prius Base >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Electric Converters and Controllers >> P112 Hybrid Vehicle Control - Component And System Testing >> Accelerator Pedal Rod >> Removal

Accelerator Pedal Rod: Removal

  1. REMOVE REAR NO. 2 FLOOR BOARD  (See REMOVAL )
  2. REMOVE REAR DECK FLOOR BOX  (See REMOVAL )
  3. REMOVE REAR NO. 3 FLOOR BOARD  (See REMOVAL )
  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  5. REMOVE ACCELERATOR PEDAL ROD 
    1. Disconnect the accelerator pedal position sensor connector.
    2. Remove the 2 bolts, then remove the accelerator pedal rod.
      Fig 1: Installing Accelerator Pedal Rod
      G05674947Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals