LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Highlander Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 41 (Cruise Control System (Hybrid)) >> Cruise Control Main Switch >> Removal

Cruise Control Main Switch: Removal

WARNING: This page is about a different variant/trim than selected.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (See PRECAUTION ).
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  2. REMOVE LOWER NO. 3 STEERING WHEEL COVER  (See REMOVAL )
  3. REMOVE LOWER NO. 2 STEERING WHEEL COVER  (See REMOVAL )
  4. REMOVE STEERING PAD  (See REMOVAL )
  5. REMOVE CRUISE CONTROL MAIN SWITCH 
    1. Remove the 2 screws.
    2. Disconnect the connector.
      Fig 1: Locating Cruise Control Main Switch Screws
      G05419696Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the cruise control main switch as shown in the illustration.
      4. Fig 2: Identifying Cruise Control Main Switch
      G05419697Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals