Cruise Control Main Switch: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL CRUISE CONTROL MAIN SWITCH
1. Install the cruise control main switch as shown in the illustration.
  
  Fig 1: Identifying Cruise Control Main Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the connector.
3. Install the 2 screws.
  Torque: 2.4 N*m (25 kgf*cm, 21 in.*lbf)
  
  Fig 2: Locating Cruise Control Main Switch Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING PAD (See INSTALLATION )
INSTALL LOWER NO. 3 STEERING WHEEL COVER (See INSTALLATION )
INSTALL LOWER NO. 2 STEERING WHEEL COVER (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INSPECT STEERING PAD (See INSTALLATION )
INSPECT SRS WARNING LIGHT
1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).