Problem Symptoms Table
Use the table below to help you find the cause of the problem. The numbers indicate the priority of the likely cause of the problem. Check each part in order. If necessary, replace parts.
MANUAL TRANSAXLE SYSTEM:
PROBLEM SYMPTOMS TABLE
| Symptom | Suspected Area | See |
|---|---|---|
| Noise | Oil (Level low) | MANUAL TRANSAXLE OIL |
| Oil (Wrong) | MANUAL TRANSAXLE OIL | |
| Gear (Worn or damaged) (Input shaft) | INSPECTION | |
| Gear (Worn or damaged) (Output shaft) | INSPECTION | |
| Bearing (Worn or damaged) (Input shaft) | INSPECTION | |
| Bearing (Worn or damaged) (Output shaft) | INSPECTION | |
| Oil leak | Oil (Level too high) | MANUAL TRANSAXLE |
| Gasket (Damaged) | DISASSEMBLY | |
| Oil seal (Worn or damaged) | REMOVAL | |
| O-ring (Worn or damaged) | DISASSEMBLY | |
| Hard to shift or will not shift | Control cable (Faulty) | REMOVAL |
| Synchronizer ring (Worn or damaged) (Input shaft) | INSPECTION | |
| Synchronizer ring (Worn or damaged) (Output shaft) | INSPECTION | |
| Shifting key spring (Damaged) (Input shaft) | INSPECTION | |
| Shifting key spring (Damaged) (Output shaft) | INSPECTION | |
| Jumps out of gear | Locking ball spring (Damaged) | DISASSEMBLY |
| Gear shift fork (Worn) | DISASSEMBLY | |
| Gear (Worn or damaged) (Input shaft) | INSPECTION | |
| Gear (Worn or damaged) (Output shaft) | INSPECTION | |
| Bearing (Worn or damaged) (Input shaft) | INSPECTION | |
| Bearing (Worn or damaged) (Output shaft) | INSPECTION |