Inspection Procedure
- CHECK DISC PLAYER CHANGER
- OK: EJECT DISC PLAYER MAGAZINE
- NG: GO TO NEXT STEP
- CHECK WIRE HARNESS (DISC PLAYER CHANGER - BATTERY AND BODY GROUND)
- Disconnect the D26 changer connector.
- Measure the resistance of the wire harness side connector.
Standard resistance
DISC PLAYER CHANGER - BATTERY AND BODY GROUND (RESISTANCE)Tester Connection Specified Condition D26-20 (GND) - Body ground Below 1 Ω - Measure the voltage of the wire harness side connector.
Standard voltage
DISC PLAYER CHANGER - BATTERY AND BODY GROUND (VOLTAGE)Tester Connection Condition Specified Condition D26-10 (+B) - Body ground Always 10 to 14 V D26-1 (ACC) - Body ground Ignition switch ACC 10 to 14 V - NG: REPAIR OR REPLACE HARNESS AND CONNECTOR
- OK: REPLACE DISC PLAYER CHANGER