Cruise Control System (Diagnostics): Precaution
- INITIALIZATION NOTE: When disconnecting the negative (-) battery cable, initialize the following system after the cable is reconnected.SYSTEM NAME REFERENCE
System Name Go To Power Window Control INITIALIZATION Sliding Roof System INITIALIZATION - EXPRESSIONS OF IGNITION SWITCH
The type of ignition switch used on this model differs according to the specifications of the vehicle.
The expressions listed in the table below are used in this section.
IGNITION SWITCH (POSITION) AND ENGINE SWITCH (CONDITION)Expression Switch Type Ignition Switch (position) Engine Switch (Condition) Ignition Switch off LOCK Off Ignition Switch on (IG) ON On (IG) Ignition Switch on (ACC) ACC On (ACC) Engine Start START Start - PAY ATTENTION TO THE FOLLOWING POINTS WHEN INSPECTING THE CRUISE CONTROL SYSTEM
- Push the cruise control main switch ON-OFF button off when not using the cruise control.
- Be careful of vehicle speed increase when driving downhill with the cruise control on.
- RESUME/ACCEL operation, after canceling the cruise control, works as RESUME, and works as ACCEL while the cruise control system is in operation.
- Push the cruise control main switch ON-OFF button off and reset the cruise control if the CRUISE main indicator light blinks while the cruise control system is in operation. If the cruise control cannot be set by this procedure or is automatically cancelled immediately after setting, there may be a malfunction in the system.
- Do not use the cruise control system where the road conditions are as follows:
- Heavy traffic
- Steep downhills
- Sharp turns
- Icy or snowy roads
- Slippery roads