LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1997 >> RAV4 2D Utility, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System - Alternator & Regulator >> On-Vehicle Testing >> Load Test

Load Test

NOTE: If battery is fully charged, disable ignition system. Crank engine for about 15 seconds to partially discharge battery.
  1. Connect an ammeter as described in NO-LOAD TEST , step 1). See Figure. Start engine. Turn on high beam headlights and place heater blower control on HI. Increase engine speed to 2000 RPM.
  2. Check ammeter reading. Ammeter should read 30 amps or more. If amperage is less than specified, repair or replace generator.
GENERATOR RATED AMPERE OUTPUT SPECIFICATIONS (AT 2000 RPM)

Application Amperes
RAV4 80
scientia non olet · About LEMON Manuals