Headlight Assembly: Installation
CAUTION:
- Install the bumper face - front so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - front (a).
- Before installing the bumper face, match the claws on the bracket - front bumper with the engaging position of flange section on the bumper face side. If the engaging position is not correct, the flange section may be broken or the clearance between fender panel and bumper face may not be uniform.
- Install the light assembly - head.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the bracket - front bumper corner.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the bumper face - front. <Ref. to INSTALLATION , Front Bumper.>
- Install the air intake duct. (When the headlight RH was removed)
- Check and adjust the clearance between the hood COMPL - front and the light assembly - head. <Ref. to ADJUSTMENT , Front Hood.>
- Connect the battery ground terminal. <Ref. to BATTERY , NOTE, Note.>
- Adjust the headlight beam and fog light beam.
- Adjust the headlight beam. <Ref. to HEADLIGHT BEAM ADJUSTMENT , ADJUSTMENT, Headlight Assembly.>
- Adjust the fog light beam. (Model with fog light) <Ref. to FOG LIGHT AIMING , ADJUSTMENT, Front Fog Light Assembly.>