Auto Headlight Beam Leveler Control Module
WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
| Terminal No. | Content | Measuring condition | Standard |
|---|---|---|---|
| 1 ←→ Chassis ground | Ignition power supply | Ignition switch ON | 8 - 16 V |
| 2 ←→ Chassis ground | GND | Always | Less than 1 Ω |
| 3 ←→ Chassis ground | Rr vehicle height sensor GND | Always | Less than 1 Ω |
| 4 | - | - | - |
| 5 | - | - | - |
| 6 | - | - | - |
| 7 | - | - | - |
| 8 | - | - | - |
| 9 | - | - | - |
| 10 ←→ Chassis ground | Leveling actuator power supply | Ignition switch ON | 8 - 16 V |
| 11 ←→ Chassis ground | Leveling actuator GND | Always | Less than 1 Ω |
| 12 ←→ 3 | Rr vehicle height sensor power supply | Ignition switch ON | 4.75 - 5.25 V |
| 13 | - | - | - |
| 14 | - | - | - |
| 15 | - | - | - |
| 16 | - | - | - |
| 17 ←→ Chassis ground | Leveling actuator signal | Headlight off → on | Less than 1 V → 1.0 - 14.4 V (for 17 seconds) |
| Headlight on, no vehicle height change → change and hold vehicle height for 3 seconds or more | |||
| 18 | - | - | - |
| 19 ←→ Chassis ground | Rr sensor signal | IG ON (with no passenger, no load and vehicle stopped) | Approx. 2.5 V (changes according to vehicle condition) |
| 20 | - | - | - |
| 21 | - | - | - |
| 22 | - | - | - |
| 23 | CAN-H | Cannot be measured (CAN communication line) | - |
| 24 | CAN-L | Cannot be measured (CAN communication line) | - |