Meter pointer indication check

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

In meter pointer indication check, the meter operation, warning/indicator light and fuel level warning light are checked.

NOTE: ILL indication illuminates at the same brightness as immediately before entering "Meter pointer indication check".

Press the trip reset switch.

After a buzzer sounds for 0.5 seconds and "STEP2" is displayed on TFT, the meter pointer indication check mode is initiated.

Time (sec)

Speedometer (km/h)

Tachometer (r/min)

Fuel gauge

Engine coolant temperature gauge

Fuel level warning light

Warning/indicator light

1.5

Lowest point

Light ON

⁽¹⁾, ⁽²⁾

1.5

1000

Light ON

1.5

100

4000

1/2

Starting point of the red line

Light OFF

1.5

140

8000

Light OFF

1.5

100

4000

1/2

Starting point of the red line

Light OFF

1.5

1000

Light ON

⁽¹⁾	Warning lights and indicator lights controlled by the meter drive circuit go off. <Ref. to SPECIFICATION , General Description.>

⁽²⁾	Warning lights and indicator lights controlled by other module are turned on/off according to the module control. <Ref. to SPECIFICATION , General Description.>