LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 23 (Engine Mechanical (H6DO)) >> Ignition Timing >> Inspection >> Method With SUBARU Select Monitor

Method With SUBARU Select Monitor

WARNING: This page is about a different variant/trim than selected.
  1. Before checking the ignition timing, check the following item:
    1. Check the air cleaner element is free from clogging, spark plugs are in good condition, and hoses are connected properly.
    2. Check the malfunction indicator light does not illuminate.
  2. Warm-up the engine.
  3. Read the ignition timing using Subaru Select Monitor. < Refer to READ CURRENT DATA FOR ENGINE (NORMAL MODE) , OPERATION, Subaru Select Monitor . >

    Ignition timing [BTDC/RPM]: 

    15°±8°/650 

    If the timing is not correct, check the ignition control system. Refer to "Engine Control System". < Refer to BASIC DIAGNOSTIC PROCEDURE . >

scientia non olet · About LEMON Manuals