Blower Unit: Installation

INSTALL BLOWER ASSEMBLY
1. Install the blower assembly with the claw in the order shown in the illustration.
  
  Fig 1: Identifying Blower Assembly With Claw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the blower assembly with the bolt and 3 screws.
  Torque: 9.8 N*m (100 kgf*cm, 7 ft.*lbf) for bolt
  
  Fig 2: Identifying Blower Assembly With Bolt And Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the 3 connectors.
  
  Fig 3: Locating Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AIR DUCT (See INSTALLATION )
INSTALL ECM (See INSTALLATION )
INSTALL INSTRUMENT PANEL SUB-ASSEMBLY LOWER
1. Install the instrument panel sub-assembly lower (see INSTALLATION ).
INSTALL INSTRUMENT PANEL SUB-ASSEMBLY UPPER
1. Install the instrument panel sub-assembly upper (see INSTALLATION ).
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
INSPECT SRS WARNING LIGHT
1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).