LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2005 >> Ion Red Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Automatic Transmission - Introduction & Repair Instructions) >> Repair Instructions >> Input Speed Sensor Installation

Input Speed Sensor Installation

WARNING: This page is about a different car, the 2005 Saturn Ion 3, 2005 Saturn Ion 2, and 2005 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: The tab on the sensor housing (46) fits into the recess on the case boss.
    IMPORTANT: For drive sprockets with 35 teeth, use a black sensor housing. For drive sprockets with 32 or 33 teeth, use a natural colored sensor housing.
  1. Assemble the input speed sensor (46) to the transmission case.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the input speed sensor bolt (15). Hand start the bolts.

    Tighten:  Tighten the input speed sensor bolt to 12 N.m (9 lb ft).

    3. Fig 1: View Of Input Speed Sensor
    GM55099Courtesy of GENERAL MOTORS CORP.
  3. Route the input speed sensor wiring harness in the case channel.
  4. Connect the input speed sensor connector to the input speed sensor.
  5. Install the wire harness retainer and wire harness retainer bolt.

    Tighten:  Tighten the wire harness retainer bolt to 12 N.m (9 lb ft).

scientia non olet · About LEMON Manuals