LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2005 >> Ion 1 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Wiper System & Washer System) >> Repair Instructions >> Wiper Drive System Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Pursuit and 2005 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wiper Module Assembly
    GM869668Courtesy of GENERAL MOTORS CORP.
  1. Install the wiper module assembly into the plenum.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the fasteners attaching the wiper module assembly to the plenum.

    Tighten:  Tighten the fasteners to 10 N.m (89 lb in)

  3. Connect the wiring connector to the wiper motor.
  4. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  5. Install the wiper arms. Refer to Wiper Arm Replacement .
scientia non olet · About LEMON Manuals