LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2005 >> 9-7X Linear >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Sir >> Repair Instructions >> Inflatable Restraint Instrument Panel Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing PSIR Inflator Module
    GM742163Courtesy of GENERAL MOTORS CORP.
  1. Install the PSIR inflator module to the front of the I/P carrier.
    2. Fig 2: Removing/Installing Side Retaining Nuts At PSIR Inflator Module
    GM846922Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 2 side retaining nuts to the PSIR inflator module.

    Tighten:  Tighten the nuts until fully driven, seated and not stripped.

    3. Fig 3: Removing/Installing 2 Lower Passenger Supplemental Inflatable Restraint (PSIR) Inflator Module Retaining Bolts
    GM762390Courtesy of GENERAL MOTORS CORP.
  3. Install the 2 retaining bolts (1) to the PSIR inflator module.

    Tighten:  Tighten the bolts until fully driven, seated and not stripped.

    4. Fig 4: Removing/Installing Air Duct Extension
    GM762387Courtesy of GENERAL MOTORS CORP.
  4. Install the passenger air duct extension though the front of the I/P.
    5. Fig 5: Removing/Installing Passenger Air Duct Extension Screw
    GM762389Courtesy of GENERAL MOTORS CORP.
  5. Install the passenger air duct extension screw (1).

    Tighten:  Tighten the screw to 2.5 N.m (22 lb in).

  6. Close the I/P compartment door.
    7. Fig 6: Identifying Right I/P Access Cover
    GM712793Courtesy of GENERAL MOTORS CORP.
  7. Install the passenger side I/P access panel.
  8. Enable the SIR System. Refer to SIR Disabling and Enabling Zone 5 .
scientia non olet · About LEMON Manuals