SOLEX 40 Pm-4 2-Barrel: Overhaul: Reassembly
Reassembly is in reverse order of disassembly but the following points should be observed:
Make certain accelerator pump diaphragm is in good condition. Check float for leaks. Use all new gaskets in reassembly. When installing main Venturis make certain that writing is facing up so that it can be read from above. Do not overtighten venturi securing screws.
CARBURETOR SPECIFICATIONS
| Main Jet | 0115 | ||
| Main Venturi | 32 | ||
| Air Correction Jet | 180 | ||
| Idle Metering Jet | 57.5 | ||
| Idle Air Bleed | 1.8 | ||
| Accelerating Pump | No. 72 | ||
| Pump Jet | 50 | ||
| Accelerating Pump Nozzle | (1) | ||
| Float Needle Valve | 175 | ||
| Float Weight | 7.4 Grams | ||
| Emulsion Tube | No. 25 | ||
| Main Jet Carrier | 6 | ||
| By-pass Ports | 1.7, 1.4, 1.0 | ||
|
|||