LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> G6 GT, 2D Convertible, 3.9 1 >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System & Fuel System - 3.9L - Repair Instructions >> Repair Instructions >> Camshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Camshaft Position Sensor & Bolt
    GM1599076Courtesy of GENERAL MOTORS CORP.
  1. Remove the power steering pump. Refer to Power Steering Pump Replacement (LZ4, LZ9) .
  2. Disconnect the camshaft position (CMP) sensor electrical connector.
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.
  5. Inspect the sensor O-ring for wear, cracks, or leakage if the sensor is not being replaced.
scientia non olet · About LEMON Manuals