Circuit/System Testing
WARNING: This page is about a different car, the 2010 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
- The I/P module
- The SDM module
- The I/P wiring harness connector
- The SDM wiring harness connector
- Turn the ignition to LOCK and remove the key.
- Connect all supplemental inflatable restraint (SIR) components and ensure that all the components are properly mounted.
- Ensure that the ignition switch has been OFF for at least 30 seconds.
- Ignition ON, observe the air bag indicator flashes 6 times.
- If air bag indicator does not flash 6 times, and same DTC is set again, replace the SDM.
- If air bag indicator does not flash 6 times, and different DTC is set then previous, refer to Diagnostic System Check - Vehicle .
NOTE:
When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector.