LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Bonneville SLE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 4.6L - Introduction) >> Repair Instructions >> Ignition Control Module Replacement - Bank 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Ignition Control Module
    GM602331Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Be sure the ignition cassette grounding spring and insulator are in place when installing the ignition cassette.
  1. Install the ignition control module.

    Install the ignition control module retaining screws.

    Tighten:  Tighten the ignition control module retaining screws to 0.8 N.m (7 lb in).

    Connect the spark plug boots to the spark plugs.

  2. Install the ignition cassette. Refer to Ignition Coil(s) Replacement - Bank 2 .
scientia non olet · About LEMON Manuals