2-Speed Functional Tests
NOTE:
Remove wiring harness connectors from wiper motor. Check mounting bolts to assure ground.
- Low Speed Test
For Horizon, Omni, Volare and Aspen without intermittent wiper motor, connect a jumper wire between terminal "L" on motor and positive battery post. The motor should run. If it runs, proceed to step 2).
If not, proceed to step 5).
For all other models and all models with intermittent wiper motor, make an additional connection from "P2" terminal to ground. Motor should run. If it runs, proceed to step 2). If not, proceed to step 5).
- High Speed Test Move jumper wire to terminal "H". Motor should run. If it runs, proceed to step 3). If not, proceed to step 5).
- Park Test
For Horizon, Omni, Volare and Aspen, without intermittent wiper, connect a jumper wire between "P2" and "L" on wiper motor. Connect a second jumper wire from battery to "P1" terminal. Wipers should park. If OK, proceed to step 4).
If not, proceed to step 5).
For all other models and all models with intermittent motor, connect a jumper wire between "L" and ground on motor. Connect a jumper wire from battery to "PI" terminal. Wipers should park. If OK, proceed to step 4). If not, proceed to step 5).
- Wiper motor is good, check switch or wiring.
- Motor is not functional, refer to SYSTEM TESTS before removing motor.