Scan Tool Data List
DASH INTEGRATION MODULE VALUE
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition ON/Engine OFF | |||
| Battery Voltage | Data | Volts | 12.6 Volts |
INSTRUMENT PANEL CLUSTER VALUE
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition ON/Engine OFF | |||
| Battery Voltage | Data | Volts | 12.6 Volts |
POWERTRAIN CONTROL MODULE VALUE
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition ON/Engine OFF | |||
| Crank Request Signal | Engine Data 2 | Yes/No | No |
| GEN F-Terminal Signal | Engine Data 1 | Percentage | 0% |
| GEN L-Terminal Signal Command | Engine Data 2 | Output/No Output | No Output |
| Ignition 1 Signal | Engine Data 1, Engine Data 2 | Volts | 13.0 Volts |
| Starter Enabled Relay Circuit Status | Output Driver Data | OK/Fault | OK |
| Starter Relay Command | Engine Data 2 | Yes/No | No |
POWERTRAIN CONTROL MODULE VALUE
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition ON/Engine OFF | |||
| Crank Request Signal | Engine Data 3 | Yes/No | No |
| GEN F-Terminal Signal | Engine Data 2 | Percentage | 0% |
| GEN L-Terminal Signal Command | Engine Data 2 | Output/No Output | No Output |
| Ignition 1 Signal | Engine Data 1, Engine Data 2, Engine Data 3 | Volts | 13.0 Volts |
| Starter Relay Command | Engine Data 3 | Yes/No | No |
TRANSMISSION CONTROL MODULE VALUE
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition ON / Transmission in Park | |||
| IMS | Transmission Data | Park, Park/Reverse, Reverse, Reverse/Neutral, Neutral, Neutral/Drive 4, Drive 4, Drive 4/Drive 3, Drive 3, Drive 3/Drive 2, Drive 2, Drive 2/Drive 1, Drive 1, INVALID, OPEN | Park |