Sleep Mode Activation

BCM receives the sleep-ready signal (ready) from IPDM E/R and combination meter via CAN communication.
BCM transmits the sleep wake up signal (sleep) to each unit when all of the CAN sleep conditions are fulfilled.
Each unit stops the transmission of CAN communication with the sleep wake up signal. BCM is in CAN communication sleep mode.
BCM is in the low power consumption mode and perform the low power consumption control when all of the BCM sleep conditions are fulfilled with CAN sleep condition.

SLEEP CONDITION

CAN sleep condition	BCM sleep condition
Receiving the sleep-ready signal (ready) from all units 1 minute after turning power switch OFF Theft warning alarm and panic alarm: Not operation Warning chime: Not operation Intelligent Key system buzzer: Not operation Stop lamp switch: OFF Turn signal indicator lamp: Not operation Exterior lamp: OFF Door lock status: No change CONSULT communication status: Not communication Meter display signal: Non-transmission Door switch status: No change Driver door lock status: No change	Interior room lamp battery saver: Time out * RAP system: Not operation Nissan Vehicle Immobilizer System (NVIS) - NATS: Not operation Remote keyless entry receiver communication status: No communication Tire pressure monitoring system (TPMS): Stop ACC/ON indicator lamp: Not operation

CAN sleep condition

BCM sleep condition

NOTE:

* : Refer to SYSTEM DESCRIPTION for details of the interior room lamp battery saver time.