Removal and Installation: Notes

CAUTION: Be careful of the following.

Before servicing, disconnect the battery cable from negative terminal.
To remove brake pipe, use a suitable tool (flare nut wrench) to prevent flare nuts and brake tube from being damaged. To install, use suitable tool (flare nut torque wrench).
Do not apply excessive impact to ABS actuator and electric unit (control unit), such as dropping it.
Do not remove and install ABS actuator and electric unit (control unit) by holding harness.
After work is completed, bleed air from brake tube. Refer to BLEEDING BRAKE SYSTEM .
After installing harness connector on the ABS actuator and electric unit (control unit), make sure connector is securely locked.

NOTE: Cap or plug opening(s) to prevent fluid from spilling.