Reference Value From Consult-II

CAUTION: The display shows the control unit calculation data, so a normal value might be displayed even in the event the output circuit (harness) is open or short - circuits.

REFERENCE VALUE FROM CONSULT-II

Monitor item	Display Content	Data monitor		Reference: Inspection item
Monitor item	Display Content	Condition	Reference values for normal operation	Reference: Inspection item
WHEEL SENSOR	Wheel speed calculated using signals from all four wheel sensors	Vehicle stopped	0 km/h (0 MPH)	, "WHEEL SENSOR SYSTEM "
WHEEL SENSOR		While driving (Note 1)	Nearly matches the speedometer display (+/- 10% or less)	, "WHEEL SENSOR SYSTEM "
IN ABS S/V OUT ABS S/V	Operation status of all solenoids	When the actuator solenoid operates or during a fail-safe	ON	-
IN ABS S/V OUT ABS S/V	Operation status of all solenoids	When the actuator relay operates and the actuator solenoid does not operate	OFF	-
EBD WARN LAMP	Brake warning lamp on condition (Note 2)	Brake warning lamp ON	ON	-
EBD WARN LAMP	Brake warning lamp on condition (Note 2)	Brake warning lamp OFF	OFF	-
STOP LAMP SW	Brake pedal operation	Brake pedal depressed	ON	, "STOP LAMP SWITCH SYSTEM "
STOP LAMP SW	Brake pedal operation	Brake pedal not depressed	OFF	, "STOP LAMP SWITCH SYSTEM "
MOTOR RELAY	Motor and motor relay operation status	When the motor relay and motor are operating	ON	, "ABS Actuator Relay or ABS Motor Relay Power System "
MOTOR RELAY	Motor and motor relay operation status	When the motor relay and motor are not operating	OFF	, "ABS Actuator Relay or ABS Motor Relay Power System "
ACTUATOR RLY	Actuator relay operation status	When the actuator relay is operating	OFF	, "ABS Actuator Relay or ABS Motor Relay Power System "
ACTUATOR RLY	Actuator relay operation status	When the actuator relay is not operating	ON	, "ABS Actuator Relay or ABS Motor Relay Power System "
ABS WARN LAMP	ABS warning lamp on condition (Note 2)	ABS warning lamp ON	ON	-
ABS WARN LAMP	ABS warning lamp on condition (Note 2)	ABS warning lamp OFF	OFF	-
BATTERY VOLT	Battery voltage supplied to ABS control unit	Ignition switch ON	10 - 16V	, "ABS Actuator Relay or ABS Motor Relay Power System "
GEAR	Determined gear shift position from the A/T PNP switch signal	Driving	M/T vehicles are always left in 1.	-
ENGINE RPM	Engine running	With engine stopped	0 RPM	Engine speed signal system
ENGINE RPM	Engine running	With engine running	Almost in accordance with tachometer display	Engine speed signal system
FAIL SIGNAL	Fail signal status	During ABS fail-safe During EBD fail-safe	ON	ABS system EBD system
Note 1: Confirm tire pressure is normal. Note 2: ON/OFF timing of ABS warning lamp ON: For approximately 1 second after the ignition switch is turned on or when an error is detected. OFF: Approximately 1 second after the ignition switch is turned on (when system is normal).