Procedure For DTC P0103

With CONSULT-II 

1. Turn ignition switch ON.
2. If 1st trip DTC is detected,

   Select "DATA MONITOR" mode with CONSULT-II.

3. Wait at least 6 seconds.
4. If 1st trip DTC is detected, go to Diagnostic Procedure .

   If 1st trip DTC is not detected, go to next step.

5. Start engine and let it idle for at least 6 seconds.
6. If 1st trip DTC is detected, go to Diagnostic Procedure .

Fig 1: Displaying DATA MONITOR Mode

Courtesy of NISSAN MOTOR CO., U.S.A.

With GST 

Follow the procedure "With CONSULT-II".