Check Sliding Sensor Circuit

WARNING: This page is about a different car, the 2006 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FUNCTION

With CONSULT-II

Check operation with "SLIDE PULSE" on the DATA MONITOR to make sure the pulse changes.

DATA MONITOR ITEM REFERENCE TABLE

Monitor item [OPERATION or UNIT]		Contents
SLIDE PULSE	-	The seat sliding position (pulse) judged from the sliding sensor signal is displayed.

Fig 1: CONSULT-II Display Data Monitor

Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT-II

Turn ignition switch OFF.

Check signal between driver seat control unit connector and ground, with oscilloscope.

SIGNAL CHECK TABLE

Connector	Terminals (Wire color)		Condition	Signal (Reference value)
Connector	(+)	(-)	Condition	Signal (Reference value)
B352	24 (R)	Ground	Sliding motor operation	Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Sliding sensor circuit is OK.

NG: GO TO 2.

Fig 2: Checking Signal Between Driver Seat Control Unit Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

CHECK SLIDING SENSOR HARNESS CONTINUITY
1. Disconnect driver seat control unit connector and sliding motor connector.
2. Check continuity between driver seat control unit connector B352 terminals 24, 31 and sliding motor B357 terminals 24, 31A.
  24 (R) - 24 (R): Continuity should exist .
  
  31 (GY) - 31A (GY): Continuity should exist .
3. Check continuity between driver seat control unit connector B352 terminals 24, 31 and ground.
  24 (R) - Ground: Continuity should not exist .
  
  31 (GY) - Ground: Continuity should not exist .
OK or NG

OK: Replace sliding motor.

NG: Repair or replace harness between driver seat control unit and sliding motor.

Fig 3: Checking Continuity Between Driver Seat Control Unit Connector Terminals 24, 31 And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.