Assembly And Installation

WARNING: This page is about a different car, the 2024 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

Use torque wrench to tighten bolts or nuts to specification.
When tightening nuts and bolts as a basic rule equally tighten in several different steps starting with the ones in center then ones on inside and outside diagonally in this order If the order of tightening is specified, do exactly as specified.
Before removing or installing any intake-system-related parts, thoroughly clean them to prevent foreign matter from entering inside engine.
Replace with new gasket, packing, oil seal or O-ring.
Thoroughly wash, clean, and air-blow each part. Carefully check engine oil or engine coolant passages for any restriction and blockage.
Avoid damaging sliding or mating surfaces. Completely remove foreign materials such as cloth lint or dust. Before assembly, oil sliding surfaces well.
After disassembling, or exposing any internal engine parts, change engine oil and replace oil filter with a new one.
Release air within route when refilling after draining engine coolant.
After repairing, start the engine and increase engine speed to check engine coolant, fuel, engine oil, and exhaust gases for leakage.