Removal And Installation: Notes

WARNING: This page is about a different variant/trim than selected.

Pre-removal operation

Under Cover Front Removal. Refer to UNDER COVER .
Transmission Oil Draining. Refer to ON-VEHICLE SERVICE .
Starter Motor Assembly Removal. Refer to STARTER MOTOR ASSEMBLY .
Drive Shaft Removal. Refer to DRIVE SHAFT ASSEMBLY .
Air Cleaner Assembly Removal. Refer to AIR CLEANER .
Battery and Battery Tray Removal. Refer to BATTERY .

Post-installation operation

Clutch Pedal Check And Adjustment. Refer to GENERAL DESCRIPTION .
Battery and Battery Tray Installation. Refer to BATTERY .
Air Cleaner Assembly Installation. Refer to AIR CLEANER .
Drive Shaft Installation. Refer to DRIVE SHAFT ASSEMBLY .
Starter Motor Assembly Installation. Refer to STARTER MOTOR ASSEMBLY .
Transmission Oil Refilling. Refer to ON-VEHICLE SERVICE .
Under Cover Front Installation. Refer to UNDER COVER .

Fig 1: Removing/Installing Transaxle Assembly Components With Torque Specification

G12680792

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Required Special Tools:

MB991928: Engine Hanger
- Slide Bracket (HI)
- MB991932: Foot (standard)
- MB991929: Joint (50)
MB991895: Engine Hanger
MB992906: Engine Hanger Attachment