General Specifications
WARNING: This page is about a different variant/trim than selected.
REAR AXLE GENERAL SPECIFICATIONS
| Item | Specification | |||||
|---|---|---|---|---|---|---|
| Rear axle | ||||||
| Wheel bearing | Type | Unit ball bearing (double-row angular contact ball bearing) | ||||
| Driveshaft Joint | Type | Outer | EUJ | |||
| Inner | ETJ | |||||
| Shaft length(1) x Shaft diameter mm (in) | 2.4L Engine: 5 persons seat | LH | 496.0 x 23 (19.53 x 0.91) | |||
| RH | 576.4 x 23 (22.69 x 0.91) | |||||
| 2.4L Engine: 7 persons seat, 3.0L Engine | LH | 505.5 x 23 (19.90 x 0.91) | ||||
| RH | 586 x 23 (23.07 x 0.91) | |||||
| Differential | ||||||
| Reduction gear type | Hypoid gear | |||||
| Reduction ratio | 2.352 | |||||
| Differential gear type (Type x number of gears) | Side gear | Straight bevel gear x 2 | ||||
| Pinion gear | Straight bevel gear x 2 | |||||
| Number of teeth | Drive gear | 40 | ||||
| Drive pinion | 17 | |||||
| Side gear | 14 | |||||
| Pinion gear | 10 | |||||
| Bearings (Outside diameter x Inside diameter) mm (in) | Side | 72 x 35 (2.83 x 1.38) | ||||
| Front | 55 x 30 (2.17 x 1.18) | |||||
| Rear | 68 x 40 (2.68 x 1.57) | |||||
|
||||||