Brush Check

WARNING: This page is about a different car, the 2005 Mitsubishi Montero. However, it is still accessible from the selected car via links, so may be relevant.

Replace the brush if the brush protrusion length shown in the illustration is below the minimum limit value.
- Minimum limit: 2 mm (0.08 inch)
  
  Fig 1: Checking Brush Protrusion Length
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
The brush can be removed by unsoldering the brush lead wire.
When installing a new brush, push the brush in to the brush holder, and solder the lead wire.

Fig 2: Identifying Soldered Brush Lead Wire
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.