Section 40 (Overhaul -- Except Evolution)
WARNING: This page is about a different variant/trim than selected.
- General Information
- Special Tools
- Transaxle
- Disassembly And Assembly
- Disassembly Steps Of Transaxle And Special Tools
- Disassembly Service Points
- Adjustment Before Assembly
- Assembly Service Points
- >> A << Output Shaft/Input Shaft Installation
- >> B << 5TH Speed-Reverse Shift Fork/5TH Speed-Reverse Shift Rail/3RD-4TH Speed Shift Fork/3RD-4TH Speed Shift Rail Installation
- >> C << Spring Pin Installation
- >> D << Spacer And Outer Race Installation
- >> E << Transaxle Case Installation
- >> F << Sealing Cap Installation
- >> G << Under Cover Installation
- >> H << Control Housing Installation
- >> I << Speedometer Gear Installation
- >> J << Select Lever Installation
- Inspection
- Disassembly And Assembly
- Input Shaft
- Disassembly And Assembly
- Disassembly Steps And Special Tools
- Disassembly Service Points
- Assembly Service Points
- >> A << Oil Seal Installation
- >> B << Ball Bearing Installation
- >> C << Snap Ring Installation
- >> D << Synchronizer Spring Installation
- >> E << Synchronizer Ring Installation
- >> F << 3RD-4TH Speed Synchronizer Hub Installation
- >> G << Synchronizer Sleeve Installation
- >> H << 4TH Speed Gear Sleeve Installation
- >> I << 5TH Speed Gear Installation
- >> J << Thrust Plate Installation
- >> K << Thrust Plate Stopper Installation
- >> L << Ball Bearing Installation
- >> M << Snap Ring Installation
- Inspection
- Disassembly And Assembly
- Output Shaft
- Disassembly And Assembly
- Notes
- Disassembly Service Points
- Assembly Service Points
- >> A << Roller Bearing Inner Race Installation
- >> B << Snap Ring Installation
- >> C << 1ST Speed Gear Sleeve Installation
- >> D << Synchronizer Spring Installation
- >> E << 1ST-2ND Speed Synchronizer Hub Installation
- >> F << Synchronizer Sleeve Installation
- >> G << 2ND Speed Gear Sleeve Installation
- >> H << 3RD Speed Gear Installation
- >> I << Snap Ring Installation
- >> J << 4TH Speed Gear Installation
- >> K << 5TH Speed Gear Sleeve Installation
- >> L << Synchronizer Spring Installation
- >> M << Synchronizer Ring Installation
- >> N << 5TH Speed-Reverse Synchronizer Hub Installation
- >> O << Synchronizer Sleeve Installation
- >> P << Reverse Gear Sleeve Installation
- >> Q << Ball Bearing Installation
- >> R << Snap Ring Installation
- Inspection
- Disassembly And Assembly
- Reverse Idler Gear
- Speedometer Gear
- Select Lever
- Control Housing
- Clutch Housing
- Transmission Case
- Differential
- Specifications