Multi-Center Display
- Multi-Center Display
- General Description
- Multi-Center Display System < Middle Grade Type >
- Failure Diagnosis Service Mode Function < Middle Grade Type >
- Multi-Center Display Diagnostic Trouble Code Diagnosis On-Board Diagnostics
- Diagnosis Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC 010: Bus Off
- DTC 011: Powertrain Control Module Time-Out (Related To Engine) DTC 012: Powertrain Control Module Time-Out (Related To A/T
- DTC 013: A/C-Ecu Time-Out
- DTC 014: Combination Meter Time-Out
- DTC 019: ETACS-Ecu Time-Out
- DTC 020: Failures Information On Powertrain Control Module (Related To Engine)
- DTC 021: Failures Information On Combination Mete
- DTC 022: Failures Information on A/C-ECU
- Symptom Chart
- Equipment Diagnosis
- INSPECTION PROCEDURE 1: Communication with Scan Tool Is not Possible. (Middle Grade Type).
- INSPECTION PROCEDURE 2: The Multi-Center Display does not Show Any Information. (Middle Grade Type) < UP TO DECEMBER 2003 >.
- INSPECTION PROCEDURE 2: The Multi-Center Display does not Show Any Information. (Middle Grade Type) < FROM TO JANUARY 2004 >
- INSPECTION PROCEDURE 3: The Multi-center Display does not Show any Information. (Low Grade type)
- INSPECTION PROCEDURE 4: The A/C Display Shows "COMMUNICATION ERROR", and then can not Proceed to Next Screen. (Middle Grade Type)
- INSPECTION PROCEDURE 5: The Ambient Air Temperature Display Shows "COM ERROR" or "-deg°C (-°F)." (Middle Grade Type)
- INSPECTION PROCEDURE 6: On the Audio Screen, "COMMUNICATION ERROR" can not Proceed to Next Screen. (Middle Grade Type)
- INSPECTION PROCEDURE 7: The Compass can not be Calibrated Manually, or Becomes Out of Calibration Easily. (Middle Grade Type)
- On-Vehicle Service
- Special Tools
- Removal And Installation
- Ambient Temperature Sensor