Cruise Control Switch Test
Disconnect cruise control switch harness connector. Remove switch. See CRUISE CONTROL SWITCH under REMOVAL & INSTALLATION. Check for continuity between specified switch terminals. See CRUISE CONTROL SWITCH TEST table. Replace as necessary.
CRUISE CONTROL SWITCH TEST
| Switch Position & Terminals No. | Condition | |
|---|---|---|
| Switch Off (1 & 2) | No Continuity | |
| CANCEL (Switch On) | ||
| 1 & 3 | About 3900 Ohms | |
| 2 & 3 | About Zero Ohms | |
| RESUME (Switch On) | ||
| 1 & 3 | About 4800 Ohms | |
| 2 & 3 | About 910 Ohms | |
| SET (Switch On) | ||
| 1 & 3 | About 4100 Ohms | |
| No. 2 & 3 | About 220 Ohms | |
| Switch On (1 & 2) | About 3900 Ohms | |