Clutch Assembly: Installation
- Align flywheel dowels with dowel holes in clutch cover. Using clutch alignment tool, install disc and pressure plate. Tighten bolts evenly, in a crisscross pattern to specification. Ensure that 2 dowel pins are installed in clutch housing.
- Clean release bearing sliding surface. Apply molybdenum grease to release bearing sliding surface. Apply a light amount of grease to input shaft splines. DO NOT allow grease or dirt on clutch disc or pressure plate surfaces. To complete installation, reverse removal procedure. Refill all fluids to proper level. Adjust clutch pedal height, travel and free play.