LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> CX-30 Select >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle (Service Information) - ET6AX-El >> Initial Learning >> Initial Learning Procedure >> Initial learning procedure

Initial learning procedure

  1. Switch the ignition ON (engine off).
  2. Connect the M-MDS to the DLC-2.
  3. Perform the following procedure using the M-MDS.
    1. Press [Start] for the vehicle identification.
    2. Press the [Toolbox] tab.
    3. Press the [Work Support] icon.
    4. Press [TRANSMISSION/TRANSAXLE].
    5. Press [Run] for Initial learning of AT.
  4. Perform the automatic transaxle initial learning.
  5. Using the M-MDS, verify that DTC P06B8:00 has not been stored. (See DTC INSPECTION
  6. If DTC P06B8:00 is displayed, switch the ignition off and repeat the procedure from Step 1.
  7. If any other DTCs are displayed, repair the malfunctioning location according to the applicable DTC troubleshooting. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (ET6A-EL, ET6AX-EL) (US)] .)
scientia non olet · About LEMON Manuals