Generator Warning Light
- Verify that the battery is fully charged.
- Verify that the drive belt deflection/tension is within the specification. (See
DRIVE BELT DEFLECTION/TENSION INSPECTION [13B-MSP]
.)
- With the ignition switch turn to the ON position, verify that the generator warning light illuminates.
- If it does not illuminate, inspect the generator warning light and the wiring harness.
- If the generator warning light and the wiring harness are normal, inspect the PCM.
- Verify that the generator warning light goes out after the engine is started.
- If the generator warning light does not go out, perform the DTC inspection, then perform troubleshooting according to the corresponding diagnostic procedure. (See
ON-BOARD DIAGNOSTIC [13B-MSP] in appropriate Engine article.) (See DTC TABLE [13B-MSP] in appropriate Engine article.
.)