B3 Check The Ignition Switch And Harness For An Open
- PCM connector disconnected.
- SJB-A connector disconnected.
- Key ON, engine OFF.
- Measure the voltage between:
( + ) PCM Connector, Harness Side ( - ) ISP-R - Pin B42 Ground - Measure the voltage between:
( + ) SJB-A Connector, Harness Side ( - ) ISP-R - Pin 3 Ground - Are the voltages greater than 10 V?
- Yes: GO to B4 .
- No:
CHECK for a damaged ignition switch.
REFER to the appropriate Component Testing article .
If the ignition switch is OK, REPAIR the open circuit.
CLEAR the DTCs. REPEAT the self-test.