LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2009 >> 5 Touring, 2.3 L >> Repair and Diagnosis >> External Pages >> Different car >> Section 581 (Lighting System) >> Steering Angle Sensor Inspection

Steering Angle Sensor Inspection

WARNING: This page is about a different car, the 2008 Mazda 5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the meter hood (See METER HOOD REMOVAL/INSTALLATION ).
  2. Remove the column cover (See COLUMN COVER REMOVAL/INSTALLATION ).
  3. Remove the steering angle sensor connector.
  4. Connect battery positive voltage to terminal A and ground to terminal D of the steering angle sensor.
  5. Turn the steering wheel to the right and left, and verify that the voltage and pulses at the terminals are as shown in the figure.
    • If not as specified, replace the steering angle sensor.
      Fig 1: Steering Angle Sensor - Blinking Pattern
      G05545906Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals