No Sliding Of Either Seat
- With control switch held in slide forward or slide backward position, measure voltage at Blue/White, Black/White and White/Red wire terminals of control switch connector. If battery voltage is not present at all terminals, replace control switch.
- If battery voltage is present at all terminals, measure voltage at:
- Blue/White and White/Red wire terminals of limit switch connector with control switch held in slide forward position
- Black/White and White/Red wire terminals of limit switch connector with control switch held in slide backward position.
- If battery voltage is not present at all terminals, repair wiring between control switch and limit switch. If battery voltage is present at all terminals, ensure continuity exists between the following terminals of limit switch connector is as follows. See Fig 1
.
- Seat fully forward - Terminals "B" and "C"
- Seat in middle position - Terminals "A", "B" and "C"
- Seat fully rearward - Terminals "A" and "C".
- If continuity is not as specified, replace limit switch. If continuity is as specified, ensure battery voltage is present at the following terminals of slide motor connector:
- Green wire with switch in forward position
- Green/White wire with switch in backward position.
- If battery voltage is not present at both terminals, repair wiring between slide motor and control switch. If battery voltage is present at both terminals, replace slide motor.
Courtesy of MAZDA MOTORS CORP.