Vertical Alignment
WARNING: This page is about a different car, the 2018 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
In order to align the Cruise-Control Module (C-CM), which is a radar sensor unit, the front bumper cover must be removed to access the sensor and the vehicle must be in a wheel alignment bay station so that the vehicle is level.
NOTE:
Damage to the C-CM bracket may affect correct alignment. When aligning the C-CM, inspect the C-CM bracket for damage and repair as necessary before carrying out the alignment procedure.
- Remove the front bumper cover. For additional information, refer to Bumpers .
- Place the vehicle on a wheel alignment bay station.
- Locate the C-CM radar sensor alignment screw.
- Place a combination square level on the face of the C-CM radar sensor unit and check the alignment.
- Keeping the combination square level on the face of the C-CM radar sensor unit, adjust the pitch of the sensor by using an E5 inverted Torx ® bit to adjust the screw until the sensor is vertical and level.
-
NOTE: Prior to installing the front bumper cover, clean and remove any debris on the front or back of the cover.
Install the front bumper cover.